Model
Puner LG-100 Plasma Cutter
Plasma cutter platform relevant to pilot arc, high-frequency start, gas valve and arc-transfer control diagnosis.
Overview
Puner LG-100 Plasma Cutter is treated in WelderData as a repair platform rather than just a product name. Many machines sold under different brands share similar internal blocks, board layouts and fault patterns. The page therefore focuses on machine architecture, board relationships and practical fault paths instead of sales specifications.
Typical internal architecture
AC input and protection
↓
Input rectifier / filter
↓
DC bus capacitors
↓
Auxiliary power supply
↓
PWM control board
↓
Driver stage
↓
MOSFET / IGBT inverter
↓
Main transformer
↓
Secondary rectifier / output inductor
↓
Welding output
What technicians normally check
- External output leads, work clamp, torch and mode switches.
- Input voltage and DC bus condition.
- Auxiliary supply rails such as 24V, 15V, 12V and 5V.
- PWM controller supply, reference and shutdown conditions.
- Driver waveform before the main power stage is fully energized.
- Power devices, snubber components, transformer and secondary rectifier board.
Why this page matters
A model-family page works as a hub. It connects a machine name to its boards, chips, circuits, fault symptoms and repair cases so a technician can move from a broad model search into a specific diagnostic path.